|
07-02-2009, 05:52 PM
| #1 |
| Senior Member Join Date: May 2006 Location: North Carolina
Posts: 471
| Brass tubing for 1/72 scale Does anyone know any place that sells hollow tubing (brass, copper, stainless steel or aluminum) that I can use for modelling 1/72 scale 15mm, 20mm and 30mm cannons? The local hobby shop here is a BIT thin on supllies. If my math is right, the 30 mm would require an Inner Diameter of 0.0164 " and an OD of say twice that or 0.0328". Haven't been able to find anything that small. I've read that it's possible to use syringe tubing but no idea where to look. Anyone have any suggestions? Last edited by kgambit; 07-02-2009 at 06:17 PM. |
|         |
|
07-03-2009, 10:44 AM
| #2 |
| Siggy Master   Join Date: Jun 2005 Location: Poland
Posts: 13,974
| For these barrels and other things I use injection needles that are available in most of drag-stores.Also you can ask for them your doctore.He should know where you can purchase them as well. These needles are offered of a few different diameters so there is no problem to fit them as barrels of 15mm, 20mm and 30mm cannons.
__________________  |
|
| |
|
07-03-2009, 01:02 PM
| #3 |
| Senior Member Join Date: May 2006 Location: North Carolina
Posts: 471
| Thanks Wurger!  |
|
| |
|
07-03-2009, 04:23 PM
| #4 |
| Siggy Master Join Date: Jun 2005 Location: Poland
Posts: 13,974
| You'r welcome. 
__________________ |
|
| |
 |
| Thread Tools | |
| Display Modes | |
| |
Linear Mode
