**** DONE: GB-46 1/32 Ki-45 - WW2 Eastern Front / Twin Engine A/C, Transports and Gliders

[Airframes]

Heck, it's like the real thing, with all that spar and internal stuff.

 

[Wurger]

 

[Crimea_River]

Heck, it's like the real thing, with all that spar and internal stuff.

And, and, that wingy thing!

 

[Gnomey]

Looks great so far Wayne!

 

[T Bolt]

This is going to be fun to watch.
I saw that parts diagram you put up in post #12 and all I could think was 'food for the carpet monster'

 

[Wayne Little]

Yeah Glenn ......dropped a few parts already that I have been prepping.....had to get the torch out and do a carpet grid search...!

This thing has so much that eventually wont even be seen....sadly.

Ok more done...wing frames below the floor either side of the main fuel tank and prepping the wing linkage rod....

 

[Wurger]

 

[rochie]

Nice

 

[Crimea_River]

A great kit for understanding the subject's construction. Hope the landing gear can take the weight.

 

[Airframes]

Impressive parts engineering.

 

[nsmekanik]

Oh looks like fun

 

[Wayne Little]

Thanks Guys.
Wing Linkage Rod, Cockpit floor sections, rudder pedals in place, and number of levers on both sides of where the seat will sit.....bits everywhere....

 

[rochie]

some incredible detail in that kit Wayne, looks great

 

[Wurger]

 

[Crimea_River]

Fascinating.

 

[fubar57]

Wow!

 

[Airframes]

Heck, that's a lot of detail and parts - very impressive !

 

[Wayne Little]

Thanks Guys.

 

[Gnomey]

Great work so far Wayne!

 

[Wayne Little]

Thanks Guys, yes there are a LOT of parts to put in this thing.......far too many of which will be damn near invisible, once the fuselage wraps around the whole thing...
I have not been idle, the past few days....into the back end of the cockpit assembly.
Cable Box and Linkage rod, gun ring assembly and seat assembly prepped and added.