GB-61 1/48 F4U-1A Corsair - Carrier and Maritime Aircraft

Ad: This forum contains affiliate links to products on Amazon and eBay. More information in Terms and rules

So, got my seat belts yesterday. Oh my, didn't count on them being this fiddly.
Learned a good lesson on the for bit of hardware for the lap belt!
Do Not cut the parts out......... assembly and Then cut the PE off the frame!!!
GB61-19.jpgGB61-20.jpg
It's just too farken difficult to control these micro sized pieces!!!!!
 
So, got my seat belts yesterday. Oh my, didn't count on them being this fiddly.
Learned a good lesson on the for bit of hardware for the lap belt!
Do Not cut the parts out......... assembly and Then cut the PE off the frame!!!
View attachment 771008View attachment 771009
It's just too farken difficult to control these micro sized pieces!!!!!
You may also have to slightly taper the end of the belt to get it into the slot. I also use UHU glue on a toothpick to hold down the fold behind the buckle. You can later seal it down when placing the belts on the seat. Hope this helps Bill. :thumbright: :D
 
Nice Bill that chappy looks like he is waiting for his Rusks. You have also seemingly had more success than I with the belts, my efforts in the last couple of days have been thwarted and I now have a Heath Robinson mix of the nice soft fabric type and Eduards discarded belts. :thumbright: :D
 

Users who are viewing this thread

Back